Pelco TV Mount C237M User Manual

C237M (3/99)  
MRWA  
Wall Mount  
®
IMPORTANT SAFEGUARDS AND WARNINGS  
Prior to installation and use of this product, the following WARNINGS should be observed.  
300 W. Pontiac Way,  
Clovis, CA 93612-5699  
USA  
1. Installation and servicing should only be done by qualified service and installation per-  
sonnel.  
In North America & Canada:  
Tel (800) 289-9100  
FAX (800) 289-9150  
2. Installation shall be done in accordance with all local and national electrical and mechani-  
cal codes utilizing only approved materials.  
International Customers:  
Tel (1-559) 292-1981  
FAX (1-559) 348-1120  
3. Use only installation methods and materials capable of supporting four times the maxi-  
mum specified load.  
4. Use stainless steel hardware to fasten the mount to outdoor surfaces.  
The product and/or manual may bear the following marks:  
This symbol indicates that danger-  
ous voltage constituting a risk of  
electric shock is present within  
U
®
L
LISTED  
C A U T I O N :  
this unit.  
RISK OF ELECTRIC SHOCK.  
This symbol indicates that there  
are important operating and main-  
tenance instructions in the litera-  
ture accompanying this unit.  
DO NOT OPEN.  
Please thoroughly familiarize yourself with the information in this manual prior to installation  
and operation.  
DESCRIPTION  
The MRWA Wall Mount is designed for indoor use with pendant-mount domes and monitor  
mounts which utilize a suitable length of 1.5-inch NPT threaded pipe for mounting.  
The MWRA mount is compatible with MR3000/MR3050/MR4050 monitor mounts and most  
Pelco pendant domes.  
INSTALLATION  
1. Determine the location for mounting your specific equipment on the wall. Remember to  
allow for adequate clearance on all sides to insure proper operation of selected equip-  
ment.  
NOTE: When determining the  
mount location, consideration  
must be given to the total weight  
of both the mount and the equip-  
ment selected for use with the  
mount.  
2. Use the mount itself as a template to mark the required mounting holes (a minimum of six  
fasteners must be used).  
3. Using the fasteners of a suitable size, attach the mount to the chosen surface.  
The mounting surface must be  
adequate to support this total  
weight.  
4. Attach the chosen equipment to the MRWA mount using a suitable length of threaded  
1.5-inch NPT pipe. Tighten set screw as shown in Figure 1. Remember to be certain that  
the mount is properly fastened to a surface adequate to support the total weight of the  
mount and equipment.  
 

Philips Car Satellite Radio System SDV6224 12 User Manual
Philips Digital Camera SPC505NC User Manual
Philips Flat Panel Television 150B3E User Manual
Philips Portable DVD Player PET830 93 User Manual
Pitco Frialator Universal Remote SSHLV14 User Manual
PMC Sierra Network Card PM5350 User Manual
Poulan Lawn Mower PRK17H42STB User Manual
Power Acoustik Car Video System ptm 750 User Manual
Powermatic Sander WB 25 User Manual
PYLE Audio Power Supply PSL32X User Manual